Components

To Start

Always grip device firmly with your bare hand touching the hand-held electrode.

Making sure that the entire Electrode Head is in contact wit your skin at all times, Move the device slowly across your skin. Once you begin a cycle, do not remove the device from your skin until the cycle is finished.

Precautions

Use after removing makeup (device cannot be used for removing makeup)
Device is not waterproof. Do not use in the bathroom or in close proximity to water.
Use once a day for approximately 5 minutes (1-minute CLEAN Mode cycle + 1-minute MC Mode cycle + 3-minute RF-Wpulse Mode cycle) up to 3 times a week. Avoid consecutive days of use by allowing at least 1 full day to pass in between uses.
Device will not operate on dry skin, so be sure to apply the specialized gel or the serum of your choice prior to use. 

Standard Way to Use

[1]CLEAN Mode Cycle (1 minute)

<step.1>Remove Cotton Stopper from device and place a cotton pad over it.	<step.2>Soack cotton pad with toner.
<step.3> Press and hold the Power/Mode Selection Button to start MC Mode cycle.	<step.4>Move the device in order from areas 1 to 6, covering each area once.

[2] MC Mode Cycle (1 minute)

<step.1> the device will automatically switch to standby MC Mode. You can also switch it manually by pressing the Power/Mode Selection Button.	<step.2> Place a dollop (about 2cm in diameter) of ReFa C.P.SERUM LIFT, ReFa C.P.SERUM GLOW or the serum of your choice on your hand, and lightly apply it to your face and neck.
<step.3> Press and hold the Power/Mode Selection Button to start MC Mode cycle.	<step.4>Move the device in order from areas 1 to 6, covering each area once.

[3] RF-Wpulse Mode Cycle (3 minutes)

<step.1> The device will automatically switch to standby RF-Wpulse Mode. You can also switch it manually by pressing the Power/Mode Selection Button.	<step.2> Plae a dollop (about 2cm in diameter) of ReFa C.P.SERUM LIFT, ReFa C.P.SERUM GLOW or the serum of your choice on your hand, and lightly apply it to your face and neck.
<step.3>Press and hold the Power/Mode Selection Button to start RF-Wpulse Mode cycle.	<step.4> Press the Level Adjustment Button to adjust the heating level from 1 to 5.
<step.5>Move the device in order from areas 1 to 5, covering each area 5 times.